10
Communication Server configuration
10
2
Other
2.1
Introduction
To support these enhanced features, ensure that the communication server has the appropriate
settings. A basic checklist of the necessary settings follows. More detailed information is available
in the Office Communications & OmniPCX Enterprise installation manuals, and in video
presentations.
2.2
Checklist for Office Communications server
T2 trunks only can be used to connect to Alarm server, ISVPN enabled
Access1 or Access2 limits: 3 digits maximum
• check and update if numbering plan required
• check and update if trunk group required
• check and update the number of allocated T2 channels
2.3
Checklist for OmniPCX Enterprise server
T2 or H323 trunks can be used to connect to Alarm server
Access1 or Access2 limits:
for H323 trunk to Alarm server: 3 digits for trunk selection, 1 digit for gatekeeper alarm server
selection.
using ARS: up to 4 digits
• create H323 trunk group
• create gatekeeper if it does not exist
• check and update if Ethernet parameters required
• check and update if COS for calling phone feature required
• name display (1) and caller ID
• check and update if timer 42 required
400GEO-301
400GEO-302
400GEO-303
To Next Page
Loading...
