Filter Policies
7210 SAS D, E OS Router Configuration Guide Page 103
protocol-id — Configures the decimal value representing the IP protocol to be used as an IP filter
match criterion. Well known protocol numbers include ICMP(1), TCP(6), UDP(17). The no form
the command removes the protocol from the match criteria.
Values 0 — 255 (values can be expressed in decimal, hexidecimal, or binary - DHB)
Protocol Protocol ID Description
icmp 1 Internet Control Message
igmp 2 Internet Group Management
ip 4 IP in IP (encapsulation)
tcp 6 Transmission Control
egp 8 Exterior Gateway Protocol
igp 9 Any private interior gateway (used by Cisco for IGRP)
udp 17 User Datagram
rdp 27 Reliable Data Protocol
idrp 45 Inter-Domain Routing Protocol
rsvp 46 Reservation Protocol
gre 47 General Routing Encapsulation
iso-ip 80 ISO Internet Protocol
eigrp 88 EIGRP
ospf-igp 89 OSPFIGP
ether-ip 97 Ethernet-within-IP Encapsulation
encap 98 Encapsulation Header
pnni 102 PNNI over IP
pim 103 Protocol Independent Multicast
vrrp 112 Virtual Router Redundancy Protocol
l2tp 115 Layer Two Tunneling Protocol
stp 118 Spanning Tree Protocol
ptp 123 Performance Transparency Protocol
isis 124 ISIS over IPv4
crtp 126 Combat Radio Transport Protocol
crudp 127 Combat Radio User Datagram
To Next Page
Loading...
