Alcatel-Lucent 7210 SAS - Filter Management Tasks; Renumbering Filter Policy Entries

Filter Policies
7210 SAS D, E OS Router Configuration Guide Page 85
Filter Management Tasks
This section discusses the following filter policy management tasks:
• Renumbering Filter Policy Entries on page 85
• Modifying an IP Filter Policy on page 87
• Deleting a Filter Policy on page 90
• Copying Filter Policies on page 92
Renumbering Filter Policy Entries
The system exits the matching process when the first match is found and then executes the actions
in accordance with the specified action. Because the ordering of entries is important, the
numbering sequence can be rearranged. Entries should be numbered from the most explicit to the
least explicit.
Use the following CLI syntax to renumber existing MAC or IP filter entries to re-sequence filter
entries:
CLI Syntax: config>filter
ip-filter filter-id
renum old-entry-number new-entry-number
mac-filter filter-id
renum old-entry-number new-entry-number
Example
: config>filter>ip-filter# renum 10 15
config>filter>ip-filter# renum 20 10
config>filter>ip-filter# renum 40 1