To Next PageTo Next Page
Need help?Do you have a question about the Alcatel-Lucent 7750 SR-a4 and is the answer not in the manual?
General| Product Type | Router |
|---|---|
| Series | 7750 SR |
| Product Family | Service Router |
| Model | 7750 SR-a4 |
| Form Factor | Chassis |
| Ports | Ethernet, 10G |
| Routing Protocols | BGP, OSPF, IS-IS, MPLS |
| Management Interfaces | CLI, SNMP |
| Power Supply | Redundant AC/DC |
| Cooling | Hot-swappable fans |
| Operating System | SR OS |
Provides site preparation recommendations and installation procedures for 7750 SR-a4/SR-a8 routers.
Describes general features of the 7750 SR-a chassis family.
Details the functions and features of the Control and Processing Module (CPM-a).
Describes the Power Supply Units (PSUs) for the 7750 SR-a chassis.
Critical warnings and notes for site preparation.
Lists the physical and slot specifications for the 7750 SR-a4 and SR-a8 chassis.
Details safety procedures and requirements for grounding AC and DC powered units.
Details the process of unpacking the 7750 SR-a chassis and components.
Details horizontal installation in a standard 19-inch EIA-310 rack.
Details how to prepare the ground wire for chassis connection.
Details the process of installing, wiring, and connecting AC PSUs.
Details the procedure for installing the fan tray into the chassis.
Describes the compact flash card used for the SR-a OS software.
Details how to establish a console connection using the RJ-45 serial port.
Explains how to configure MDA-a cards before provisioning their ports.
Details the LEDs and connectors for PSU modules.
Details procedures for removing and replacing PSU modules.
Critical warnings and notes for fan tray removal and replacement.
Step-by-step instructions for removing an air filter.
Step-by-step instructions for removing a CPM-a module.
Explains how to shut down ports, cards, and MDAs for IOM-a replacement.
Explains how to change MDA-a configuration when replacing cards.
Identifies the ports available on the CPM-a module.
Details pin assignments for management ports.
Describes pinout assignments for the alarms interface port.
Critical warnings and notes for handling pluggable transceivers.
Step-by-step guide for installing SFP, SFP+, CSFP, or QSFP+ transceivers.
