Alcatel-Lucent 7750 SR-a4 - Establishing Router Management Connections; Console Connection

Establishing Router Management Connections
128 7750 SR-a4 and SR-a8 Installation Guide
Establishing Router Management Connections
There are two ways to access the management interface for the 7750 SR-a:
• Console Connection on page 128
• Telnet Connection on page 129
Console Connection
The Console port on the CPM has an RJ-45 serial port connector. To establish a console
connection, you need the following:
• an ASCII terminal or a PC running terminal emulation software set to the parameters
shown in Table 53
• a standard RJ-45 serial cable, as described in Table 54
For pinout information, see Console Port Pinouts RS-232 DCE Mode on page 213.
Table 53: Console Configuration Parameter Values
Parameter Value
Baud Rate 115 200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
Table 54: Console Configuration Parameter Values
Cable Type DTE/DCE Switch
Null modem DTE
Straight-through DCE