This section describes how the licenses affect the Alcatel-Lucent OmniPCX Office
Communication Server.
3.4.2 Standard telephony
The number of sets allowed can be changed without reset, it means that all the devices are
accepted but the sets, which exceed the limit, are put out of service (as it would be done by
OMC) due to a SWL reason.
When a new SWL is entered, a search for Out Of Service sets for SWL reason is carried out
and if allowed, are put into service.
3.4.3 Alcatel Reflexes sets
The sets are taken into account in their apparition order.
When a set is not allowed, its apparition is accepted, but the set is put "Out of service" due to a
SWL reason. So if the attendant set appears after the limit is reached, it is refused.
UA sets behind TSC DECT or TSC/IP are not counted. NOE TDM sets are taken into account
in this counter.
Licensing will accept 5 more sets than the limit, only if the system is not in default state. This
margin is only applied if the system is not in PPU mode.
3.4.4 Analog interfaces
The interfaces are taken into account in their apparition order. When there are only 10 licenses
for analog access and when the analog board contains more than 10 accesses, only the first
10 accesses will work.
When an interface is not allowed, Its apparition is recognised but the interface is put "Out of
service" (as it would be done by OMC) due to a SWL reason.
Licensing will accept 5 more interfaces than the limit, but only if the service is opened (if the
limit is different than 0) and if the system is not in default state.
This margin is only applied if the system is not in PPU mode.
A port of an external voice mail is counted as an analog set.
3.4.5 Mobility
3.4.5.1 Number of mobile sets and TSC Dect
The number of devices are limited at the set registration. When the limit is reached, the
registration is accepted but the set is put "Out of service".
All Dect sets are counted: 4072, 4074, 4073, TINY, TSC Dect and other manufacturers sets.
Licensing will accept 5 more sets than the limit, but only if the service is opened (if the limit is
different than 0).
This margin is only applied if the system is not in PPU mode.
3.4.5.2 Number of mobile IP sets
The number of devices is limited at the set registration. When the limit is reached, the
Chapter
3
# %$
3-10
To Next Page
Loading...
Need help?
General
