November 2013 AOS Release 6.4.6.R01 Release Notes
Auto-Upgrading - Step 1. Create the AlcatelDebug.cfg file
A file named AlcatelDebug.cfg must be created and FTPd to the /flash/working directory on the switch.
This file will be read after the uboot/miniboot and AOS image upgrade to determine which FPGA/CPLD
version to use to perform the automatic FGPA/CPLD upgrade.
• The CMMs must be certified and synchronized and running from Working directory after
transferring the AlcatelDebug.cfg file to the switch.
• This procedure will require a reboot of the switch or stack.
• Make sure the destination paths are correct when transferring the files. Also, when the transfer
is complete, verify the file sizes are the same as the original indicating a successful binary
transfer.
1. Use the editor on the OmniSwitch or any text editor create and FTP the AlcatelDebug.cfg file to
the /flash/working directory on the switch.
2. Certify and synchronize the CMMs.
Contents of AlcatelDebug.cfg file:
debug set auto_update_fpga_copper 17
debug set auto_update_fpga_u24x 12
debug set auto_update_fpga_retry 1
Page 54 of 80 OmniSwitch 6850E/6855/9000E—Release 6.4.6.R01
To Next Page
Loading...
