AOS Release 6.4.6.R01 Release Notes November 2013
Verifying the U-Boot/Miniboot and FPGA Upgrade
To verify that the FPGA was successfully upgraded on a CMM, use the show hardware info command as
shown below. These names and files will differ based on the type of switch and upgrade requirements.
-> show hardware info
CPU Type : Motorola MPC8248,
Flash Manufacturer : Wintek CF128MB,
Flash size : 131203072 bytes (125 MB),
RAM Manufacturer : 0x00000000 - Other,
RAM size : 536870912 bytes (512 MB),
NVRAM Battery OK ? : YES,
Uboot Version : 6.4.5.398.R02,
Miniboot Version : 6.4.5.398.R02,
Product ID Register : ff
Hardware Revision Register : 30
CPLD Revision Register : 12
XFP Module ID : 02
You can also view information for each switch in a stack (if applicable) using the show ni command as
shown below.
-> show ni
Module in slot 1
Model Name: OS6850E-24X,
Description: 24 G 2 10G,
Current Switch mode : OS6850E,
Saved Switch mode : OS6850E,
Part Number: 902937-90,
Hardware Revision: 07,
Serial Number: L408029P,
Manufacture Date: MAR 15 2011,
Firmware Version: ,
Admin Status: POWER ON,
Operational Status: UP,
Power Consumption: 0,
Power Control Checksum: 0x66b7,
CPU Model Type : Motorola MPC8248,
MAC Address: 00:e0:b1:d3:09:01,
ASIC - Physical 1: BCM56514_A0,
FPGA - Physical 1: 0012/00,
UBOOT Version : 6.4.5.398.R02,
UBOOT-miniboot Version : 6.4.5.398.R02,
POE SW Version : n/a
OmniSwitch 6850E/6855/9000E------ Release 6.4.6.R01 Page 57 of 80
To Next Page
Loading...
