November 2013 AOS Release 6.4.6.R01 Release Notes
Auto-Upgrading - Step 3. Upgrade the FPGA/CPLD
After the switch reboots during the uboot/miniboot and AOS image upgrade it will read the contents of the
AlcatelDebug.cfg file to determine the proper FPGA/CPLD upgrade version. The switch/stack will then
automatically upgrade the FPGA/CPLD. Once complete enter the following to complete the upgrade:
If you have a single CMM enter:
-> copy working certified
If you have redundant CMMs enter:
-> copy working certified flash-synchro
Verifying the Update
The following examples show what the code versions should be after upgrading to AOS Release 6.4.6.R01.
These names and files will differ based on the type of switch and upgrade requirements.
Verifying the Software Upgrade
To verify that the AOS software was successfully upgraded to 6.4.6.R01, use the show microcode
command as shown below. The display below shows a successful image file upgrade.
-> show microcode
Package Release Size Description
------------+---------------+--------+-----------------------------
Kbase.img 6.4.6.125.R01 15510736 Alcatel-Lucent Base Software
K2os.img 6.4.6.125.R01 2511585 Alcatel-Lucent OS
Keni.img 6.4.6.125.R01 5083931 Alcatel-Lucent NI software
Ksecu.img 6.4.6.125.R01 597382 Alcatel-Lucent Security Management
Page 56 of 80 OmniSwitch 6850E/6855/9000E—Release 6.4.6.R01
To Next Page
Loading...
