EasyManuals Logo

Alcatel-Lucent Stellar AP Series User Manual

Alcatel-Lucent Stellar AP Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
Stellar AP | Deployment & Configuration & Troubleshooting Guide 37 |
P a g e
All rights
reserved. Passing on and copying of this document, use and
communication of its contents not permitted without written authorization from
HAN-Networks.
# tftpboot 0x42000000 OAW-AP1230-UBOOT_FIRMWARE_3.0.x.x.bin
# nand erase 0x0 0x10000000 && nand write 0x42000000 0x0 $filesize &&
nand read 0x42000000 0x3000000 $filesize
# nand read 0x43000000 0x0 $filesize && md5sum 0x43000000 $filesize
# nand read 0x44000000 0x3000000 $filesize && md5sum 0x44000000
$filesize
# reset
After AP reboot, entering below commands to make dual system working.
# fm_switch
# reboot
4.4.5 AP1251
Procedure of the upgrading AP1250 Series through bootloader:
To setup a TFTP server on a PC, and put the images on the TFTP server path:
OAW-AP1250-UBOOT_FIRMWARE_3.0.x.x.bin
To enter the bootloader during AP initialization, which is described in 4.4.1.
Network configuration (IP Address, TFTP Server Address…)
Example: IP address=
172.16.18.11
; TFTP Server Address=
172.16.18.129
# set ipaddr 172.16.18.11
# set serverip 172.16.18.129
# save

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent Stellar AP Series and is the answer not in the manual?

Alcatel-Lucent Stellar AP Series Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelStellar AP Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals