4. Set the required temperature
The temperature can be set from +5°C to +30°C in steps of 0.5°C.
Warm water is always available (50°C) when the boiler is on and running on LPG or electricity.
During summer, when only warm water is required, adjust the temperature setting to below the surrounding
temperature so that the central heating pump does not start.
MENU
C22
Off
On
3 kw
1. The temperature displayed is
the temperature which is set at
present (in this case 22.0°C).
2. Raise the temperature by
pressing the + button. Lower
the temperature by pressing the
– button.
3.The settings are ready and the
central heating pump will work
at the set temperature.
5. Warm water
If you need more warm water, you can raise the water temperature temporarily from 50°C to 65°C.
After 30 minutes, the boiler reverts to normal operation. When you have selected more warm water the circulation
pump stops.
MENU
C22
Off
On
3 kw
MENU
C22
Off
On
3 kw
1. Increase the quantity of warm
water by pressing the + button.
2. The settings are ready.
1. Reset the warm water by
pressing the – button.
2. The settings are ready.
If you wish to revert to the basic warm water settings before 30 minutes have expired.
GB
To Next Page
Loading...
Need help?
General
