12
4. Set the required temperature
The temperature can be set from +5°C to +30°C in steps of 0.5°C. Warm water is always available (50°C) when the
boiler is on and running on LPG and/or electricity. During summer, when only warm water is required, adjust the tem-
perature setting to well below the surrounding temperature so that central heating circulation is not called for.
1. The temperature displayed is
the temperature which is set at
present (in this case 22.0°C).
2. Raise the temperature by
pressing the + button. Lower
the temperature by pressing
the – button.
3. The settings are ready and the
central heating will circulate at
the set temperature.
5. Hot water boost
If you need more warm water, you can raise the water temperature temporarily from 50°C to 65°C. After 30 minutes,
the boiler reverts to normal operation. While hot water boost is activated, the circulation pump is stopped.
1. Increase the quantity of warm
water by pressing the + button.
When activated the plus sym-
bol changes colour to green.
2. The settings are ready.
1. Reset the warm water by
pressing the – button.
2. The settings are ready.
If you wish to revert to the basic warm water settings before 30 minutes have expired.
+22°C
ON
2 kW
To Next Page
Loading...
Need help?
General
