49
GB
Outdoor sensor error
disconnected, please press the "dismiss" button in the control panel.
CI-bus error
couplings, and your vehicle's master panel. If the error persists, contact Alde Service Partner.
iNet Connection error
press the "dismiss" button in the control panel.
Remote Control error
"uninstall" button on the control panel.
9.1 If a fault persists
Disconnect 12 V from the boiler by disconnecting the cable that supplies the boiler from the boiler
circuit board. This cable is located at the top left of the circuit board. Reconnect 12 V by reconnecting
the cable.
If a fault persists even after disconnecting and reconnecting 12 V to the boiler, please also disconnect
Service Partner.
9.2. Operating messages
An operating message is not a fault but a temporary service interruption. If an error occurs, an error
message will appear on the screen.
Fan restarts...
minutes. This is not a fault. If "Fan failure" appears after several "Fan restarts...", then a fault has
occurred. Please wait for as long as "Fan restarts..." appears.
Full gas power unavailable
section 6.5 Energy sources.
If the message arrives without High Altitude Mode being turned on and the error persists, contact
Alde Service Partner.
Fig. 20. Couplings on the boiler circuit board
12 V
Load monitor
Outdoor temperature sensor
Option card
Sensor 1
Sensor 2
Yellow connector
Red connector
Fig. 21. Connectors on the control panel
To Next Page
Loading...
Need help?
General
