Assembly
This chainsaw comes fully assembled in the box
and does not require any pre-assembly.
Changing / Replacing the Guide Bar
and Chain
WARNING: The chain has sharp edges. Use
work gloves for safety.
WARNING: Ensure the engine is
switched o when making any adjustments to the chain and bar.
IMPORTANT: The front guard / chain brake (13) must be disengaged
when installing the guide bar (19) and chain (20)(Fig A).
1. Disengage the chain brake (13) by pulling the front guard / chain brake
firmly towards the top handle (12) (Fig A). Remove the chain drive side
cover (23) by using the combination tool (bar nut tube spanner) (33) in
an anti-clockwise direction to loosen the chain drive side cover nuts (24).
Remove the 2 x chain drive side cover nuts (24) and remove the chain
drive side cover (23) (Fig B). Ensure the chain brake (13) is NOT engaged.
2. With the chainsaw on its side and the bar uppermost, (Fig C), push the
guide bar (19) towards the drive sprocket (29) (Fig D), which will result in
the chain (20) loosening around the guide bar (19).
3. Remove the chain (20) from the guide bar (19) starting at the nose of the
guide bar first. Once the chain (20) is removed from the guide bar (19), the
slack chain can be removed off the main drive sprocket and lifted over the
brake and clutch assembly (38). The guide bar (19) is then removed
B. D.C.
FLAT
NOTE: SIDE VIEW
Assembly
A.
BRAKE
ON
BRAKE
OFF
TIGHTENLOOSEN
To Next Page
Loading...
