The chain teeth are extremely sharp and could
create a safety hazard if the bar cover (31) is not
fitted. Furthermore, the bar cover (31) provides
protection to the chain cutting edge when the saw
is not in use (Fig AR).
WARNING: The chain has sharp edges.
Use work gloves for safety.
Vents:
1 . Clean any dust away from the cooling vents as clogged vents can cause
overheating.
Servicing
• It is recommended once you rst use your product to get it serviced after
15 hours of use.
• From thereafter, service the product every 2 years, or every 50 hours of
use if frequently used.
Transportation and Storage
Always fit the chain and bar cover (31) when the chainsaw is not in use.
It is recommended to drain BOTH fuel and oil from the chainsaw on the
completion of use, prior to storage or transportation.
Always sit the chainsaw on a surface where the leakage of oil will not be
a problem. The chainsaw is fitted with an oil pump and there will be after
use an amount of oil in the oil channels inside the chainsaw, and also in the
chain and bar channel. This oil can spill on to the surface the chainsaw is
sitting as it drains from the above points.
Always store the chainsaw in a area safe away from the elements of the
environments, i.e. high humidity, wet locations, hot environments etc.
Storage area should also be out of reach of children of both the chainsaw,
mixing bottle and all accessories.
Store the chainsaw inside the supplied carry case ensuring the bar cover
securely covers the chain (20) and guide bar (19).
The chainsaw should always be stored with the On/Off switch (4) in the ‘Off’
position and the chain brake (13) ON.
If the chainsaw is to be stored for a long period of time it is advisable to
apply a thin spray of oil over the chain (20), guide bar (19) and all exposed
metal parts.
The chainsaw should be thoroughly cleaned of all wood chips, dirt etc prior
to storage.
AR.
Maintenance
To Next Page
Loading...
