Troubleshooting
Problem
Possible Cause Solution
Engine will not start No spark in the spark plug (17)
Flooded engine
Clean the spark plug (17).
Replace the old spark plug (17) with a
new one.
With the on/o switch (4) o, remove
spark plug (17) from the engine. Move choke
control (10) to the RUN position (pushed in
completely), and pull the recoil starter (11)
15 to 20 times. This will clear excess fuel from
engine. Clean and reinstall spark plug (17),
air filter (14), and air filter cover (15). Lift the
on/off switch (4) to the “On” position. Pull
the recoil starter (11) three times with choke
control (10) at RUN. If engine does not start,
move choke control (10) to CHOKE and
repeat normal starting procedure.
If engine still fails to start, repeat procedure
with a new spark plug (17).
Engine starts but will
not accelerate
properly.
Carburettor requires adjustment.
Chain brake (13) is engaged.
Refer to page 21 for adjustment, however,
It is recommended this adjustment is per-
formed by a Service Agent.
Release chain brake (13).
Engine does not reach
full speed and/
or emits excessive
smoke
Check oil / fuel mixture
Air filter (14) is dirty
Carburettor requires adjustment.
Chain brake (13) is engaged.
Use fresh fuel and the correct 2-stroke oil mix
ratio 40:1. Refer to fuel mixing section of manual.
Clean air filter (14).
Refer to page 21 for adjustment, however, It is
recommended this adjustment is performed by a
Service Agent.
Release chain brake (13).
Guide bar (19) and
chain (20) running hot
and smoking.
Chain tension too tight.
Check guide bar (19) and chain (20)
assembly.
Guide bar (19) and chain (20) are
damaged.
Re-tension the chain (20).
Refer to “Changing / Replacing” of the
Guide Bar and Chain” section in manual.
Inspect guide bar (19) and chain (20) for
damage.
For other issues not covered in this chart, please call Customer Service on 1800 909 909.
Troubleshooting
To Next Page
Loading...
