Air Filter:
1. Loosen the air filter cover (15) by using your
thumb to pull the air filter cover clip (16) down
to release and remove the cover (Fig AL).
2. Loosen the wing nut by turning in an anti-
clockwise direction (Fig AN), then remove the
wing nut and washer holding down the air filter
(14), and remove.
3. Split the air filter into its two parts (Fig AO) and
clean the mesh. Dry particles can be removed
by tapping on a hard surface. More stubborn
dirt may require washing out the air filter (14)
with warm soapy water and soft brush.
4. Re-assemble the two halves and replace the air
filter (14). Replace the washer and wing nut,
and in a clockwise direction, secure the wing
nut. Replace the air filter cover (15) and secure
the air filter clip (16) by using your thumb
pushing up and in towards the chainsaw until
the air filter cover clip (16) engages and is
secure (a click will be heard when it is secured
into position and closed).
Guide Bar:
1. Take off the guide bar (19) and maintain it by
removing any sawdust from the groove in the
guide bar (Fig AP).
2. Make sure that the oil port is not clogged. Oil
the nose sprocket at the tip of the guide bar (19)
(Fig AQ).
3. Check for fuel and oil leakage and loose
fastenings, especially those securing the
handles and the guide bar (19).
If any defects are found, take the tool to an
authorised Service Agent.
4. A bar cover (31) is supplied with this chainsaw
and should be fitted over the chain (20) and
guide bar (19) whenever the chainsaw is not
being used. This includes immediately after use,
transportation and service where possible.
A P.
AO.
AN.
AQ.
Maintenance
LOOSEN
TIGHTEN
To Next Page
Loading...
