Fuelling the Chainsaw
WARNING: Always ensure the engine is
turned off before undertaking this task.
Never add fuel to a machine with a running or hot
engine. Move at least 9m (30 ft.) away from the refu-
elling site before starting engine.
Do not smoke when refuelling or operating the
chainsaw.
1. Rest the chainsaw on its side so the fuel tank (8) is
facing up, on the ground or a secure surface and
wipe any debris from around the fuel tank (8).
2. Unscrew the fuel tank cap (9) (anti clockwise
direction), and pour the fuel and oil mixture into
the tank with the aid of a funnel, to about 80% of
its capacity (Fig Q).
NOTE: Be careful not to spill any mixture. If this
happens, wipe the spill with a clean rag.
3. Secure fuel tank cap (9) (Fig R).
Adding Chain Oil
WARNING: Always ensure the engine is
turned off before undertaking this task.
WARNING: Never start work unless the chain
(20) and guide bar (19) are lubricated.
1. Place the chainsaw on its side with the oil tank
cap (7) facing up. Unscrew and remove the oil
tank cap (7) (anti clockwise direction) (Fig S).
2. Using a funnel, fill the oil tank (6) to 80% capacity
with chain oil (Fig T).
3. Fasten the oil tank cap (7) and wipe up any oil
spillage.
Q.
T.
S.
LOOSEN
Filling up with Fuel and Oil
R.
LOOSEN
TIGHTEN
TIGHTEN
To Next Page
Loading...
