While cutting, always:
• Run the chainsaw motor at full revs. This makes the job safer, as there is
less chance of pull-in or kick-back.
• Position your body to the left of the chainsaw so if it kicks back
uncontrollably, it goes over your right shoulder. Never stand in the
cutting line of the chainsaw.
• Keep a rm grip with your left hand on the front handle, with your thumb
securely below the handle.
• The swivel of your wrist in a kick-back situation will activate the
chain brake.
• Make sure the chain is tensioned correctly.
Guard against Kickback
Check the operation of the front guard / chain brake (13) each time you
use the chainsaw. Run the chainsaw at full throttle for 1-2 seconds then
push the front guard / chain brake (13) forwards. The chain (20) should stop
immediately. If the chain (20) is slow to stop or only slows down you must
take the chainsaw to an authorised Service Agent. Disengage the front
guard / chain brake (13) by pulling the front guard backwards until you hear
a click (Fig A).
Do not use the chainsaw if the front guard / chain brake (13) is not operating
correctly.
• Be constantly aware of the position of the upper quadrant of the blade
tip. This is the part that triggers a kickback when it hits resistance.
• Never engage the upper quadrant of the guide bar (19) with whatever
you are cutting and avoid contact with any hidden branches or
obstructions. Ensure there is a clear work area.
• Always clear away brush, vegetation and any obstructing debris before
attempting a cut that might trigger a kickback.
• Avoid cuts that will cause the chainsaw to jam in a tree trunk or limb.
• Observe the size of wood shavings, if they become dusty your chain (20)
could need sharpening.
Operation
To Next Page
Loading...
