7
Using the bottle opener
• Read this manual to familiarize yourself with the
appliance. Pay particular attention to the safety
instructions on the previous pages.
• Unplug the appliance from the power supply before
using the bottle opener.
• To open a bottle, grasp it and position the cap
under the metal hook part in the bottle opener
(see Fig. 4).
NOTE: Be sure the bottle neck is not under the metal
hook part, or the glass may break. Hold the
can opener with one hand and pull down to
pop the cap off with the other one.
• The bottle opener will only remove metal bottle
caps. Do not use it for a bottle with screw-off cap or
pull ring cap.
NOTE: The can required to be opened should be between 2 inches (50mm) to 4
inches (100mm) in diameter and 7 inches (178mm) max in height. In the
case total weight of can is over 18 0z (510g), it is necessary to press and
hold the can opener to avoid overturning. DO NOT operate the can opener
continuously for more than 1 minute.
CAUTION: Avoid touching the cut edges of the can or lids as they are sharp.
Carefully remove the lid from the magnet and discard.
Can opening tips
• This can opener should not be used to open cans designed to open by another
method, such as a pull tab, peel-off foil seal, rolling key, rimless cans or cans
with angled corners.
• If there is a dent in the rim of a can, open the other end or start the cutting action
just beyond the dent.
Hold the can
opener with
one hand
Pull down to pop
the cap off with
the other hand
Fig. 4
Instructions
To Next Page
Loading...
Need help?
General
