1. If necessary and to avoid corrosion, dry the contact
points
25
of the GPS watch thoroughly before
starting the charge process.
2. Secure the clip on the USB cable
2
on the GPS
watch
1
(see fig. D).
NOTICE!
Risk of damage!
Incorrectly connecting the cable may cause
the watch or cable to heat up.
− Make sure that the USB cable is connected
so that the metal pins on the clip lock di-
rectly into the contact points of the watch.
3. Connect the USB cable with a USB charger or a USB
port on your computer carrying power. There is no
need to install a driver for charging the battery pack.
If the GPS watch has been switched off, it automatically
switches on when charging.
The icon of a charging battery appears on the display
panel
13
during the charging process.
If the battery pack is fully charged, the “FULL” indicator
will appear.
4. Pull the USB plug out of the USB charger or PC.
5. Carefully take the clip for the USB cable off of the GPS
watch.
To Next Page
Loading...
Need help?
General
