To put the chest strap on:
1. To ensure proper contact with the skin, wet the
gummed surface of the chest strap
7
with a small
amount of warm water or apply a small amount of
ECG gel (available in special medical stores)
(see fig. F).
2. Use the snap fasteners to connect the transmitter
unit
8
with the chest strap (see fig. G).
3. Adjust the chest strap so that it is fitted firmly on the
chest under the pectoral muscles and the
transmitter
unit is the right way around (see fig. H).
4. Switch the GPS watch to workout mode and have it
display your heart rate (see section “Workout mode
with GPS”). The heart beat icon
17
or
22
or in the
top row
15
will start flashing and your heart rate
will be displayed after a short time.
If this is not the case, refer to the chapter
“Troubleshooting”.
To Next Page
Loading...
