ALDI FERREX 161CC - Attaching the Upper Handle Bar to the Lower Handles

AFTER SALES SUPPORT
(toll free)
4 Stroke Petrol Lawn Mower
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. DM46P-DO160 • 09/2018 • 60751
21
1300 889 028
info.aldi@positecgroup.com
10/2019 10852
screw the lower handle locking knob (8) over the plastic curved washer
and secure by turning clockwise until tight and secure. (Fig D)
Attaching the Upper Handle Bar to the Lower Handles
1. Before positioning the upper handle bar (1), check if the orientation of the
upper handle bar is correct, which can allow the variable speed switch
cable (3) to run down the upper and lower handles to the engine. Ensure
the cable is not tangled in any way. (Once assembly of the upper handle
bar is complete, the cable clip can be used to secure the variable speed
switch cable (3) into position). (Fig E)
2. Once the upper handle bar is correctly
orientated for assembly to the lower handles (6),
apply the upper handle locking levers (5) (from
accessory bag) into position on the outer sides
of the upper handle bar (1) loosely (Fig F). When
both upper handle locking levers (5) are both in
position, secure and tighten.
G.
E.
C.B. D.
TIGHTEN
LOOSEN
Assembly
F.
TIGHTEN
LOOSEN