4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. DM46P-DO160 • 09/2018 • 60751
(toll free)
22
info.aldi@positecgroup.com
1300 889 028
10/2019 10852
Assembly of the Hard Catcher
WARNING. Ensure the motor is o and
not operating when undertaking this task.
1. The hard catcher (7) is supplied in two sections.
Locate the top half on top of the bottom half and
interlock them together by aligning the clips on
the top half of the catcher into the raised ridge
around the bottom half of the catcher, then push
the halves together until they click into place. (Fig H)
Attaching the Hard Catcher
WARNING. Ensure the motor is o and not operating when
undertaking this task.
1. Lift the rear discharge guard (10) in order to position the catcher. (Fig I)
NOTE: DO NOT ever start the mower if the rear discharge guard (10) does
not fully return to the close position if the catcher is not tted.
2. Apply the hard catcher (7) by aligning the catcher attachment bar (12) on
the catcher over the catcher attachment bracket (11) centrally so the catcher
is sitting evenly. (Fig J)
3. Release the rear discharge guard (10) to secure the catcher in place. (Fig
K)
NOTE: Always empty the hard catcher (7) before it has reached maximum
I.
Assembly
H.
3. Apply the cable clip (4) (from your accessory bag) to ensure the cable is secure
in position and not tangled. (Fig G)
capacity, otherwise it will decrease the
performance of the mower.
TIP: Do not leave clippings in the catcher for
extended periods.
To Next Page
Loading...
