AFTER SALES SUPPORT
(toll free)
4 Stroke Petrol Lawn Mower
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. DM46P-DO160 • 09/2018 • 60751
25
1300 889 028
info.aldi@positecgroup.com
10/2019 10852
Fuelling
WARNING: Do not rell fuel tank while engine is running or is hot.
Ensure the motor is switched o before undertaking this task.
IMPORTANT: Fuel goes o after about 3-4
months. If you nd your mower does not
start, rst change the fuel in the fuel tank (14) with
newly purchased fuel and open the fuel bowl drain
screw (23) for approximately 5 seconds to drain out
any old fuel from the motor.
1. To open the fuel bowl drain screw (23), use a
10mm spanner (not supplied), and loosen the
drain screw in an anti-clockwise direction to
remove the screw (Fig P). Fuel should drain from
the bottom of the bowl.
2. To reseal the fuel bowl drain screw (23), replace
the screw and using a 10mm spanner (not
supplied), tighten the drain screw in a clockwise
direction until rm and the discharge stops.
• Be careful not to admit dust, dirt, water or other
foreign objects into the fuel.
• Wipe o spilt fuel thoroughly before starting
engine.
• Ensure you DO NOT put fuel in the lawn mower in close proximity to any
open ames, lit cigarettes, or hot objects.
NOTE: Do not use ethanol based fuel. Use fresh unleaded fuel.
1. Unscrew the fuel tank cap (15) in an anti-clockwise direction (Fig Q), and
pour fresh unleaded fuel into the fuel tank (14) with the aid of a funnel.
2. Fill the tank to approximately 2.5 cm below the lowest portion of the neck
to allow for fuel expansion. Be careful not to over ll.
3. Be careful not to spill any petrol. If this happens, wipe the spill with a
clean rag.
4. Start the engine at least 3 metres away from the area where the fuel tank
(14) has been lled in order to avoid the risk of re.
WARNING: Never attempt to refuel the engine while it is running
or still warm, allow it to cool before fuelling.
P.
TIGHTEN
LOOSEN
Preparation
Q.
OPEN
To Next Page
Loading...
