0151 649 1500 1890 946244
www.einhell.co.uk
12
Electric Impact Shredder – GLEKS 2440Safety
Safety devices (Fig. 4a – 4d)
A
The shredder has a safety switch (Figure 4a/Item A) in its interior on the motor housing.
The control unit for it (Fig. 4b/Item 7) is located on the inside of the loading tunnel. If
the release screw (Fig. 4c/Item 12) is loosened, the switch will operate and turn off the
power to the motor. If this happens, then tighten the release screw.
11
The motor is protected from overloads by an overload switch. In case of overloading the
equipment will shut down automatically. To restart the motor, set the On/Off switch to
the position 'I' to start or restart the electric motor.
4
The plunger (Fig. 4d/Item 4) is used to remove jammed objects from the loading tunnel
inlet (Do not use anything else for this function).
Fig. 4a
A
Fig. 4c
12
11
Fig. 4b
7
Fig. 4d
4
66926_3430345_11026_ug_inner.indd 12 22/03/2016 3:22 pm
To Next Page
Loading...
