0151 649 1500 1890 946244
www.einhell.co.uk
28
Electric Impact Shredder – GLEKS 2440Safety
– Never remove debris from the machine, while the electric
motor is running.
– To remove debris from the chain and chain bar, switch the
machine off and pull out the 13A plug. Then unscrew the
release screw
12
, to allow the loading tunnel to pivot, thus
giving access to the cutting area (See Fig 5a–5d on Page 26).
– All protective and safety devices must be immediately
remounted once the repairs or maintenance are complete.
8. Residual risks
Despite being used properly, certain residual risk factors cannot
be completely ruled out. The following risks associated with the
design and construction of the impact shredder may apply:
– Contact with exposed material being drawn into the loading
tunnel inlet (cutting hazards).
– Unforeseen, abrupt movement of the material being drawn into
the loading tunnel inlet (cutting hazards).
– Flung parts from the ejector chute (cutting/ejection hazards).
– Flung parts of the material being drawn into the loading tunnel
inlet (ejection hazards).
– Hearing loss in the event of failure to use the required ear
protection.
– Inhaling of work material particles or dust. (Danger of
poisoning).
– The appliance must be used correctly.
– The material must be fed into the loading tunnel inlet in the
correct way and handled properly.
66926_3430345_11026_ug_inner.indd 28 22/03/2016 3:22 pm
To Next Page
Loading...
