GB IRE
GB
01904727501
IRE
019022605
Starting and stopping
NOTICE!
Risk of damage!
Using the 2.2 kW high pressure washer without water could result
in damage.
− Never operate the 2.2 kW high pressure washer without water
as dry operation could damage the pump. Use a water filter if
the supplied water is contaminated.
Starting
1. Open the valve for the water inlet (see fig. 7, page 16).
2. Unlock the yellow safety lock
17
of the spray gun
15
by pushing it down until it
locks into place.
3. Depress the trigger
16
until a steady flow of water is dispensed (see fig. 9). Then
let go of the trigger.
4. Set the ON/OFF switch
5
to ON to switch the 2.2 kW high pressure washer
6
on
(see fig. 10).
5. Depress the trigger again to start cleaning.
Stopping
1. Release the trigger
16
.
2. Set the ON/OFF switch
5
to OFF to switch the 2.2 kW high pressure washer
6
off
(see fig. 8, page 16).
3. Close the valve for the water inlet.
4. Briefly push the trigger until the pressure in the 2.2 kW high pressure washer has
been released.
5. Lock the trigger by folding the yellow safety lock
17
up until it locks into place.
This prevents unwanted reactivation.
Figure 9 Figure 10
To Next Page
Loading...
Need help?
General
