identical replacement parts. This will ensure that the safety of the power tool is
maintained.
b) Never service damaged battery packs. Service of battery packs should only be
performed by the manufacturer or authorized service providers.
Drill safety warnings
1) Safety instructions for all operations
a) Wear ear protectors when impact drilling. Exposure to noise can cause
hearing loss.
b) Hold the power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory or fasteners may contact hidden
wiring. Cutting accessory or fasteners contacting a “live” wire may make exposed
metal parts of the power tool “live” and could give the operator an electric shock.
c) This appliance must be used with a residual current device with a rated
residual current of 30mA or less.
2) Safety instructions when using long drill bits
a) Never operate at higher speed than the maximum speed rating of the
drill bit. At higher speeds, the bit is likely to bend if allowed to rotate freely
without contacting the workpiece, resulting in personal injury.
b) Always start drilling at low speed and with the bit tip in contact with the
workpiece. At higher speeds, the bit is likely to bend if allowed to rotate freely
without contacting the workpiece, resulting in personal injury.
c) Apply pressure only in direct line with the bit and do not apply excessive
pressure. Bits can bend causing breakage or loss of control, resulting in personal
injury.
7
To Next Page
Loading...
Need help?
General
