AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
24V Lithium-ion Cordless Drill with Hammer Action
MODEL: №.CDI224 • 09/2020 • 63524
21
The low voltage cut out feature has been added to maximise the life of the
battery cells in the battery pack (9). When this occurs, recharge the battery
pack by following the battery charging section in this manual.
NOTE: Attempting to restart the tool without either recharging the battery
or installing another battery pack (with charge) will lead to drill/driver
restarting and then stopping again, after only a few seconds of operation.
Drill/driving metals
• Always clamp sheet metal.
• Support thin metal with a block of wood to avoid distorting it.
• Use a punch to mark the centre of the hole.
• Use a suitable lubricant for the material you are working on：
USE: FOR:
Oil Steel
Turpentine or paran Aluminium
Do not lubricate Brass, copper or cast iron
Do not Lubricate Concrete based material
Drill/driving plastics and plastic coated chipboard
• Use high speed drill/driver bits
• See drill/driving wood below
Drill/driving wood
• Clamp a piece of scrap wood to the back of your work to prevent
splintering.
Hammer drill operations.
• Where possible, use High speed.
• Select the hammer position on the function selection collar (3).
• Use drill bits specically for masonary applications.
• Ensure to wear safety glasses.
Drill / driving
To Next Page
Loading...
Need help?
General
