700W AIRLESS SPRAY STATION
21
700W AIRLESS SPRAY STATION
20
10. CLEANING
WARNING! Do not use mineral spirits or paint thinner on water
based or latex spray material. Use warm soapy water to clean water
based or latex spray material and mineral spirits for oil based spray
material/paint.
WARNING! Always ground the spray gun by holding it against the
edge of a metal container if flushing with flammable solvent. Failure to
do so may lead to static electric discharge, which may cause a fire.
10.1 Flushing the system
a) Lock the trigger and remove the spray tip guard and spray tip assembly.
b) Submerge the suction tube and return tube into a bucket with the
appropriate cleaning solution.
c) Aim the spray gun into a waste container. Unlock, pull and hold the
trigger.
d) Whilst pulling the trigger, turn on the airless spray station and turn the
Prime/Spr
ay knob to SPRAY position.
e) Keep holding the trigger while the cleaning solution flows from the spray
gun until the cleaning solution is clear.
f) Release the trigger to stop the flushing.
g) Turn the Prime/Spray knob to the PRIME position and pull the trigger to
relieve pressure.
10.2 Unclogging the spray tip
DANGER! Do not use your finger, needle or other sharp pointed
object to clean the spray tip.
a) Turn the Prime/Spray knob to the PRIME position and pull the trigger to
relieve the pressure.
b) Lock the trigger.
c) Turn the spray tip arrow 180° so that the arrow is pointing backward.
d) Turn the Prime/Spray knob to the SPRAY position.
e) Point the spray gun at a piece of wood or cardboard, unlock and pull the
trigger to blow out the obstructions. When the spray tip is clean, material/
paint will come out in a straight, high pressure stream.
f) Release and lock the trigger.
g) Turn the spray tip arrow so that it is pointed forward (in spray position).
h) Unlock and pull the trigger to resume spraying.
10.3 Cleaning the spray gun filter and spray gun tip assembly (Fig.15,16)
WARNING! The spray gun filter and spray gun tip assembly must be
cleaned every time you use the airless spray station. The filter may need
to be cleaned more often when using thicker paint.
a) Release the pressure from the hose.
b) Remove the spray gun from the spray
hose by holding the nut of the hose with
a wrench and turning the spray gun.
c) Unclip the trigger guard (A) from the
filter housing (B), unscrew the filter
housing.
d) Remo v e the fi l te r (C ) f ro m t h e
filter housing and clean it with the
appropriate cleaning solution (war
m,
soapy water for water based or latex
material and mineral spirits for oil based
material/paint).
e) Remove the spray tip (E) from the spray
guard assembly. Clean the spray tip with
a soft brush and appropriate cleaning
solution. Be sure to remove and clean
the washer (F) and saddle seat (G).
f) Replace the cleaned filter into the spray
gun housing. The tapered end (D) must
be placed properly into the spray gun.
Fig.15
Fig.16
Cleaning Cleaning
To Next Page
Loading...
