EasyManua.ls Logo

ALDI Workzone Titanium+ 85509 - Material and Paint Selection

ALDI Workzone Titanium+ 85509
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
700W AIRLESS SPRAY STATION
13
700W AIRLESS SPRAY STATION
12
h)
Plastics can cause static sparks. Never hang plastic sheets to enclose
the spray area.
Do not use plas
c drop cloths when spraying ammable
materials.
i)
Always read the paint manufacturer's thinning instructions
before
use .
j)
Always keep the spray nozzle in place during use.
Never allow the spray
to come in direct contact with the skin.
k)
Always disconnect from mains supply when refilling
the paint container.
l)
Switch off when not spraying.
Avoid running the airless spray st n
there is no paint inside the paint container.
m)
Never use the airless spray station outside when it is raining.
n)
Switch off immediately
if there is an interrup
the mains or smoke.
o)
Do not use materials containing bleach or chlorine.
p)
Do not use halogenated hydrocarbon solvents
such as bleach,
mildewcide, methylene chloride and trichloroethane.
q)
Paints, solvents, insecticides and other materials can be harmful if
inhaled or come in contact with the body.
Vapours can cause severe
nausea, fain
r poisoning.
r)
Do not spray outdoors on a windy day.
s) If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
Safety Instructions For Airless Spray Station
7. MATERIAL AND PAINT SELECTION
WARNING! Do not use textured wall paints or coatings as this will
block the spray gun tip and damage internal components of the airless
spray station.
7.1 Material and paints which can be used:
The following materials and paints can be used. Although a large number
of materials and paints can be sprayed, some cannot. Please check with the
manufacturers' recommendations.
Water based paints Wood preservatives
Oil based paints • Primers
Enamel paint Wash primer
Varnish • Oil
Stains
7.2 Materials and paints which cannot be used:
The use the following materials and paints will cause premature wear and
block the spray tip. This will void warranty.
a) Paints and lacquers containing heavily abrasive components such as
Exterior textured wall paints • Dispersion paints
Glazes • Caustic and alkaline substances
Lyes
Textured coating
Acids • Emulsion paints
b) Silicate paints
c) Flammable materials
Material And Paint Selection
support@coreservice.co.uk
01904 727506
01247 5150
GB
IRE
support@coreservice.co.uk
01904 727506
0
1247 5150
IRE

Related product manuals