Alemite 8700 - Page 8

SER 8700 High-Pressure Hydraulic Pump
Revision (2-13) 8 Alemite LLC
24. Install the outer component assembly onto the inner
assembly.
• Use a slight twisting motion to pass the Seal.
• At the same time thread the Adapter into the base of
the hydraulic motor.
IMPORTANT: Make sure the flange portion
of the Adapter seats flush against the base of
the air motor. Should a gap exist, inspect the
components of the air motor packing group.
25. Install Stop Washer (23) into the Extension.
26. Install and seat Seal (24) [heel end first] into Valve
Body (25).
27. Install the Valve Body assembly (Seal first) onto
Primer Rod (27).
• Make sure the Valve Body assembly seats properly
in the Extension.
28. Install Follower Tube (31) over the outer tube
assembly.
29. Install O-Ring (32) onto Primer Body (33).
30. Install and seat Valve Seat (26) [large diameter first]
into the Primer Body.
31. Install and seat Gasket (4) into the Primer Body.
32. Screw the Primer Body onto the Extension.
33. Place a large wrench or other suitable tool into the slot
of the Primer Body.
• Tighten all the components of the assembly securely.
• Crush all Gaskets.
34. Extend Primer Rod (27) from the Primer Body.
35. Install Primer Disc (29) onto the Primer Rod.
36. Gently screw Nut (30) onto the Primer Rod.
• Use an appropriate size punch in the hole of the
Primer Rod to prevent rotation. See Figure 2.
• Do not overtighten.
Loctite, 222, and 242 are trademarks of Henkel Corporation in the U.S. and elsewhere. ®
Trademark Office.
denotes a trademark registered in the U.S. Patent and