Chapter 6: Modulation and Envelopes
162 ANDROMEDA A6 REFERENCE MANUAL
DISPLAY
PAGE PANEL LABEL
PARAMETER
DISPLAY
OPTIONS
or RANGE
DESCRIPTION
LOOP
Continued
—
COUNT
Continued
SUSTAIN
The loop will continue to cycle until the key is
let go (or the A6 receives a MIDI Note Off). If
you’re using a sustain pedal, the loop will
cycle as long as the pedal is down.
INFINITE
The loop will cycle infinitely. There are,
however, differences between infinite looping
of
ENV 3 and ENVs 1 and 2. ENV 3, which is
dedicated to the amplitude of the voice, will
literally loop forever or until you change to
another Program or power the A6 off.
If
ENV 1 and ENV 2 are set to an infinite loop,
they will loop until the Release 2 time of
ENV 3
reaches its 0 level.
—
TYPE
This parameter determines how the loop
cycles.
FORWARD
The loop cycles normally in a forward
direction. Smoothing and Count settings will
be in effect.
REVERSE
The loop cycles backward through the stages.
Smoothing and Count settings will be in effect.
ROKROL
“Rock-n-Roll”: The loop cycles backward and
forward through the stages. Count settings
will be in effect but Smoothing is ignored as it
is not needed.
—
SMOOTH
Smooth Time
2 M ···
131.05 S
When a loop repeats, it is quite possible that
the level of the start stage will be different than
the level of end stage. This may cause the
envelope to sound uneven or choppy each
time the loop cycle starts over.
While this may be desirable in some cases (just
set
SMOOTH to 0), you can adjust the transition
into the level of the start stage to be gradual,
accomplished by a function called smoothing.
This parameter sets the amount of time
smoothing will take where
0 is instantly and
65535 is maximum, approximately 32
seconds.
SSHAPE
Smooth Shape
LINEAR
EXP 1,
2 & 3
LOG 1,
2 & 3
SCURV1
& 2
Selects the slope that the Smooth Time will
follow during the smoothing transition.
These curves are the same as the envelopes’
Stage Slopes – see page 139.
To Next Page
Loading...
Need help?
General
