Need help?Do you have a question about the Alesis MASTERLINK ML-9600 and is the answer not in the manual?
Audio Specifications| ADC | 24-bit 128X oversampling |
|---|---|
| DAC | 24-bit 128X oversampling |
| Sample rates supported | 44.1kHz, 48kHz, 88.2kHz, 96kHz |
| Word lengths supported | 16-, 20-, and 24-bit |
Analog I/O| Frequency response at 44.1kHz/48kHz | 20Hz – 20kHz +0dB, -0.3dB |
|---|---|
| THD+N at 44.1kHz/48kHz | <0.002% @1kHz, -1dBFS |
| Signal-to-noise ratio at 44.1kHz/48kHz | 113dB, A-weighted |
Digital I/O| Supported protocols type I | IEC 958 |
|---|---|
| Supported protocols balanced | AES/EBU |
| Supported protocols coaxial | Coaxial |
Weight and Dimensions| Height | 3.5"/2U |
|---|---|
| Width | 17" |
| Depth | 11" |
Lists key new features and improvements in MasterLink software version 2.00.
Explains how to check for and obtain MasterLink software version 2.00.
Describes seamless track playback and implications of real-time DSP.
Explains the process and usefulness of splitting a single track into two.
Details the process of combining two adjacent tracks into a single track.
Describes creating a new track during recording without losing audio data.
Explains the new capture method for adjusting track start/end pointers.
Provides instructions on how to duplicate an audio file on the hard drive.
Allows overriding the warning when deleting an audio file used by a playlist.
Details how to copy and paste DSP parameters between tracks.
Explains how to paste previously copied DSP parameters to another track.
Describes how to reset all DSP parameters on a track to factory defaults.
Explains how to commit real-time DSP changes permanently to the audio file.
Notes the increased resolution for the peak limiter output adjustment.
Explains the new ability to loop tracks, playlists, or entire CDs.
Describes how to back up playlists and DSP settings to a CD.
Details how to restore playlists and DSP settings from a backup CD.
Explains how to render a playlist to the hard drive without burning a CD.
Describes how to add offsets to CD track start/end times to compensate for player variances.
Lists the additional system information now available in Utility Page 9.
Explains how to copy all tracks from a CD to the current playlist at once.
Notes the improved prompt for playlists exceeding CD capacity.
Details improvements for Macintosh compatibility with CD24 discs.
To Next Page
