Chapter 4
ALESIS ML-9600 REFERENCE MANUAL 1.00 17
Figure 4.5.1
Start and End Time Offset Page
The cursor defaults under the "St Offset" field; if you press UP/YES while in this field the "En
Offset" parameter will be displayed. To the right of the offset field is the "Offset Amount"
field. Pressing CURSOR RIGHT will move the cursor to the offset amount field, where
pressing the UP/YES or DOWN/NO buttons will adjust the offset amount between 0 and 30
CD frames (0 and 400mS).
NOTE: If the End Time offset is greater than the space between Tracks, the offset time will not
be applied for that track.
Both Start and End Time offsets default to 15 frames (200mS).
4.6 ENHANCED SYSTEM INFORMATION DISPLAY
Additional Pages have been added to Utility Page 9: System Information. This Page now
displays:
• Software Version – This is your main system software version. As of the writing of this
addendum, the most current version of system software is version 2.00.
• File System Version – This is the current version of the file system that manages data on
the hard disk drive. The most current version of the file system is 2.00.
• Eprom Version
• CD Drive Information
• Hard Drive Information
Most of this information is only of interest to Alesis technical support staff; however you may
wish to copy the information onto a piece of paper and store it in a safe place in case you
experience a problem with your unit and need to contact Alesis.
To Next Page
Loading...
Need help?
Audio Specifications
Weight and Dimensions
