16
6. In this first tab labeled “Inputs,” you can decide which of the MasterControl’s channels will be
routed to the Cubase’s inputs. Click the entries under “Device Port” to select an available channel
from a drop-down menu. (This number and kind of available channels will vary depending on the
sampling rate.) If necessary, you can add more buses by clicking the “Add Bus” button.
7. In the “Outputs” tab, you can decide which of the Cubase channels will be routed to the
MasterControl’s outputs. Click the entries under “Device Port” to select an available channel from
a drop-down menu. Note that the only available options are the six physical outputs (the MON /
LINE OUTPUTS on the rear panel of the MasterControl).
To Next Page
Loading...
