Need help?Do you have a question about the Alesis iO Dock and is the answer not in the manual?
Signal-to-Noise Ratio| Balanced Main Outputs SNR | 102 dB (A-weighted) |
|---|---|
| Balanced XLR Mic Inputs SNR | 92 dB (A-weighted, -35 dBV input level) |
| Balanced 1/4" TRS Mic/Line Inputs SNR | 92 dB (A-weighted, -1 dBV source level, input gain knob at min.) |
THD+N| Balanced Main Outputs THD+N | 0.005% |
|---|---|
| Balanced XLR Mic Inputs THD+N | 0.009% |
| Balanced 1/4" TRS Line Inputs THD+N | 0.005% |
Input Sensitivity| Balanced XLR Mic Inputs Sensitivity Max | -45 dBV |
|---|---|
| Balanced XLR Mic Inputs Sensitivity Min | -3 dBV |
| Balanced 1/4" TRS Mic/Line Inputs Sensitivity Max | -27 dBV |
| Balanced 1/4" TRS Mic/Line Inputs Sensitivity Min | +16 dBV |
| Unbalanced 1/4" TS Mic/Line Inputs Sensitivity Max | -27 dBV |
| Unbalanced 1/4" TS Mic/Line Inputs Sensitivity Min | +16 dBV |
| Unbalanced 1/4" TS Guitar Input Sensitivity Max | -38 dBV |
| Unbalanced 1/4" TS Guitar Input Sensitivity Min | +4.5 dBV |
Frequency Response| Frequency Response Range | 20 Hz – 20 kHz (+ 0.7 dB) |
|---|
Connect your iPad to the iO Dock's dock connector.
Connect the power adapter to the DC input for power.
Switch to turn the iO Dock on or off.
Restraint to prevent accidental unplugging of the power cable.
Connect speakers or amplifiers to these 1/4" TRS outputs.
Listen directly to input sources without iPad processing.
Connect microphones or line-level devices via XLR or 1/4" TRS.
Connect instruments or devices via XLR or 1/4" TRS.
Select input type for high-impedance guitar or mic/line signals.
Adjusts the input signal's gain level.
Activates +48V phantom power for XLR microphone inputs.
Connect a footswitch for MIDI start/stop messages to the iPad.
Connect to composite video input using RCA cable.
Adjusts the output volume of the MAIN OUT.
Adjusts the output volume of the PHONES output.
Connect 1/4" TRS headphones to this output.
Connect to an external MIDI device's MIDI IN using a 5-pin cable.
Connect to an external MIDI device's MIDI OUT using a 5-pin cable.
Send MIDI information to/from a computer via USB.
To Next Page
