6
TOP PANEL FEATURES
This section breaks down the control surface into its functional areas. The area being discussed is
shaded in the accompanying diagrams.
A
F
F
F
F
D
E
G
B
C
(A) Analog Input Signal Indicators
(B) DAW Control: Channels
(C) DAW Control: Multi-Function Knobs
(D) DAW Control: Transport
(E) DAW Control: Assignable Button Banks
(F) Monitoring / Control Room Features
(G) Configuration Controls
(A) ANALOG INPUT SIGNAL INDICATORS
1
1. SIGNAL / CLIP – There is one LED for each analog input channel. This LED turns green when
signal is detected and turns red when the signal nears 0dBFS (zero decibels full-scale, the point
where nasty digital distortion occurs). Avoid digital distortion either by reducing the trim on the first
two inputs or by reducing the volume level on any equipment connected to the analog inputs.
To Next Page
Loading...
