Installation
Unpacking
Follow the instruction below to unpack the components of the port filter
WARNING
Risk of personal injury.
There can be sharp edges, splinters, and nails on the crate and the equipment.
Wear personal protective equipment when handling the equipment during unpacking and
installation. Handle the equipment with precaution. See Section Personal protective equipment in
Chapter Safety
1
Prepare an area with required space for
unpacking.
2
Open the transport enclosure.
3
Check your shipment immediately upon
arrival and make sure that the port filter
received is in accordance with the order
specification. In the event of damage, defects
or deficiency, immediately report the problem
to the transport company and Alfa Laval.
4
Remove all additional components such as
conical guide ring or other delivered parts
from the transport enclosur.
5
Lift the port filter from the transport enclosure.
Use lifting equipment with straps attached
according to picture or by hand for smaller
port filters.
CAUTION
Risk of damage to equipment.
Handle the port filter with care to avoid
any damage of it. Avoid to expose the
port filter for bending forces as risk of
collapsing the filter tube increases.
200001927-2-EN-GB6
To Next Page
Loading...
Need help?
General
