P.22
SCENE
SCENE PROGRAMMING
1 ∙ Press and hold PROGRAM button for three seconds to activate program mode. The LCD next to "program"
blinks, indicating the program has been started.
2 ∙ Select a xture to program, by pressing any or all SCANNER buttons 1 to 12.
3 ∙ Adjust the faders to the desired output level for all channels (i.e. Color, Gobo, Pan, Tilt, etc.) of selected
xture or xtures. Press PAGE SELECTOR A/B if the xture has more than 8 channels. When selecting from
Page A to B, you have to move sliders to activate channels.
4 ∙ If you have set the xture to your liking and wish to program another xture, press the SCANNER button
you have nished adjusting. This will hold the xture in it's nal conguration. Select another xture/s by
pressing the target SCANNER button and proceed to adjust the faders. To achieve the settings you desire.
5 ∙ Repeat steps 2 and 3 until you have set the xtures the way you like.
6 ∙ When entire scene is set to your liking press and release the MIDI/ADD button.
7 ∙ Select the desired bank to store scene using BANK
et . There are 30 banks you can store up to 8 scenes
per bank for a total of 240 scenes.
8 ∙ Then press a Scene Button 1-8 to store the scene. All LEDs blink 3 times. The LCD will display the bank and
scene where scene was stored.
9 ∙ Repeat steps 2-8 to record your desired scenes.
You can copy the settings from one scanner button to another in case
you want to add more xtures to your show. Just press and hold the scanner
button you want to copy, then press the scanner button you want to copy to.
To exit programming mode press and hold the Program button for 3 seconds.
(When you exit programming, the Blackout Led is on, press Blackout button
to de-function blackout.)
QUICKQUICK
TIPS
To Next Page
Loading...