P.24
SCENE
MIDI
MANUAL RUN SCENES
When the power is rst turned on, the unit is in manual scene mode. If in Program mode, press and hold the
PROGRAM button for three second and the program LED will go out. The controller is now in Manual mode.
1 ∙ Be sure that the AUTO & MUSIC buttons' LEDs are off.
2 ∙ Select the Bank, using the BANK
et buttons that stores the scenes you wish to run.
3 ∙ Press the SCENE Button to run the scenes you selected.
AUTO RUN SCENES
This function will run a blank of programmed scenes in a sequential loop.
1 ∙ Press AUTO/DEL once to activate the Auto Run mode.
2 ∙ Use the BANK
et buttons to select a bank of scenes to run.
3 ∙ Now you can use the SPEED and FADE Sliders to adjust the scenes to you liking. The fade setting should
never be slower than the speed setting or the scenes will not be completed.
4 ∙ You can change banks on the y by pressing the BANK
et buttons.
MUSIC RUN SCENES
1 ∙ Press the MUSIC/BANK COPY button and the corresponding indicator light will come on in LCD.
2 ∙ Select desired bank that stores the scenes you wish to chase by swing
et buttons or you can control
via MIDI signals.
3 ∙ Press MUSIC/BANK COPY once more to exit.
MIDI RUN SCENES
Select bank to run scenes using MIDI whenever it is in Manual Au to or Music Run mode.
To Next Page
Loading...