P.19
MENU AND CONTROLS
Set
SETTINGS
Set
Run Mode Random
DMX Address 001
Channel Mode Std 14CH
Top Lamp Temp 080
Sound regulator +005
Invert Pan OFF
RUN MODE
DMX Slave status: Receive DMX signals from the console or Master
AUTO Auto run
Master status: Auto run and send DMX
signal to slave
Random
Sound
DMX ADDRESS
001-512 Press “OK” key enter into edit status, then press “UP” “DOWN” to change DMX
address. press “OK” key save and exit edit status.
CHANNEL MODE
14CH Standard 14 Channel Mode
TOP LAMP TEMP
0-110
SOUND REGULATOR -006/+006
INVERT PAN
ON
ON for starting and ending , the default is OFF
OFF
INVERT TILT
ON
ON for starting and ending , the default is OFF
OFF
PAN-TILT SWAP
ON Exchange Pan/Tilt channel (include Pan/Tilt Fine)
OFF
PAN-TILT ENCODER
ON
Use encoder (optocoupler) to determine out of step and automatically correct
position
OFF Correct position without encoder (optocoupler)
NO DMX SIGNAL
KEEP Continue running as it is
CLEAR All motors return to the position and stop running.
DISPLAY
ON
OFF
LOAD DEFAULT OK
Press the "OK" button to see the conrmation dialog, press "OK" again
The key restores the default settings
To Next Page
Loading...