2 Flash PURPLE BIP wait time 1 to 6 2
RED Strobe Ramp scale 1 to 5 2
GREEN Strobe Eye error time 2 to 12 7
BLUE Strobe FSDO 1 to 30 5
YELLOW Strobe FSDO time 1 to 10 10
7
7
.
.
1
1
C
C
h
h
a
a
n
n
g
g
i
i
n
n
g
g
s
s
e
e
t
t
t
t
i
i
n
n
g
g
s
s
Select an option above. Pull and hold the trigger for 1.5 seconds, the LED will turn off. Release
the trigger and the LED will blink, in the setting color, the number of the current value. To skip
displaying the current value, press and release the trigger quickly. To change the current value,
pull and release the trigger the number of the desired new value. The LED will blink WHITE each
time the trigger is pulled - wait 3 seconds.
If the new setting has changed the LED will blink WHITE the number of times of the new value,
then flash multiple colors. You are back at the main menu. If the setting was not changed the LED
will blink in the setting color, the number of times of the old value and then flash multiple colors to
show you are back in the main menu.
To change other settings, cycle through the menu by pressing and releasing the trigger. To exit
programming mode, turn the marker OFF.
S
S
o
o
l
l
i
i
d
d
R
R
E
E
D
D
Dwell 1 to 40 Default = 12
Duration in milliseconds of signal sent to the solenoid. It is important to adjust to your marker.
Solenoids react differently.
A low dwell will result in velocity inconsistency; too high causes inefficiency.
Changing to a higher dwell can cause higher or unsafe velocity. Always use a
chronograph after adjusting the dwell.
Solid GREEN Electrical debounce 1 to 20 Default = 2
Controls how aggressively the chip filters for an electronic switch bounce. A higher value is less
likely that multiple shots are fired on a single trigger pull
Solid BLUE Mechanical debounce 1 to 20 Default = 6
A higher value is less likely to fire more than one shot or “bounce” especially when firing slowly.
Default setting of 6 is a conservative value. You might want to try this value at 2 or 3, for faster
shooting semi-auto mode.
Solid YELLOW TON M-Debounce 1 to 20 Default = 6
Controls a mechanical bounce, especially at higher speeds. Higher value means the system is
more likely to pick up and eliminate mechanical bounce, but it also slows you down.
Solid PURPLE Ball In Place (BIP) delay 1 to 40 Default = 2
The delay after a ball is in breach before the marker fires. Setting adjusts in 0.5 milliseconds per
increment. Setting 2 means 1 ms. Slower loaders require a higher value. Adjust to the right value
for your loader. Low setting with slow loader can cause Eye Malfunction
Blinking RED Max ROF Eyes On 1 to 30 Default = 20
The maximum rate of fire while the eyes are on.
Setting Value
1 Uncapped
22
To Next Page
Loading...