Need help?Do you have a question about the Alinco DR-150 and is the answer not in the manual?
General| Modes | FM |
|---|---|
| Channels | 200 |
| Antenna Impedance | 50 Ω |
| Tuning Steps | 10 kHz |
| Supply Voltage | 13.8 V |
| Sensitivity | Less than 0.2 µV for 12 dB SINAD |
Lists standard and optional accessories included with the transceiver.
Details on transceiver placement in a vehicle and power connection.
Instructions for setting up the transceiver for fixed base operation.
Detailed technical parameters for DR-150T and DR-150E models.
Explains the main functions of front panel controls and their page references.
Details secondary functions accessed by briefly pressing the F key.
Explains advanced functions activated by holding the F key.
Explains the meaning of various icons and text indicators shown on the display.
Describes microphone controls and illustrates pin assignments.
Steps for powering on, adjusting volume, and setting the squelch level.
How to change the transceiver's frequency using the dial or UP/DOWN keys.
How to set transmit frequency and output power levels.
Steps for initiating a transmission using the PTT and understanding TX/RX indicators.
Explanation of VFO, Memory, and Call modes and how to switch between them.
Introduction to memory channels, scan edges, and call channels.
How to select and recall programmed memory channels.
How to temporarily alter a memory channel's frequency.
Procedure for storing operating conditions into memory channels.
Steps to clear programmed memory data or reclaim a memory channel.
Introduction to Band, Programmed, and Memory scan types.
Programming scan range limits (L and U) into memory for programmed scanning.
How to set up and activate priority watch to monitor a specific channel.
How to activate the key lock to prevent accidental function changes.
Steps for transferring transceiver data (VFO, memory) to another unit.
Returns all settings, memory, and data to factory default values.
Using DTMF codes for selective communication and call alerts.
Procedure to select a decoder frequency for tone squelch.
How to choose between Code Squelch, Group Pager, or Private Pager modes.
Procedure for programming 3-digit DSQ codes, including wild card use.
Process of transmitting codes and receiving calls with matching codes.
Process for sending group codes and receiving calls in group pager mode.
Process for transmitting individual codes and receiving calls in private pager mode.
Storing DTMF codes into memory for auto-dialing.
Steps to initiate and use remote control functions via the microphone.
Table of common problems, their possible causes, and solutions.
To Next Page
