Need help?Do you have a question about the Alinco DR-150E and is the answer not in the manual?
General| Frequency Range | 144-146 MHz |
|---|---|
| Mode | FM |
| Voltage | 13.8 VDC |
| Tuning Steps | 5 kHz |
| Receiver Sensitivity | 0.16 μV (12 dB SINAD) |
| Receiver System | Double conversion superheterodyne |
Lists standard and optional accessories included with the transceiver for setup.
Details mobile and base station installation procedures, including antenna and power requirements.
Provides technical specifications for the DR-150T and DR-150E models.
Describes the primary functions of each button and dial on the transceiver's front panel.
Explains the meaning of various icons and indicators shown on the transceiver's display.
Details the rear panel connectors and microphone pin assignments for operation.
Covers powering on, adjusting volume and squelch, and understanding reception indicators.
Explains how to select frequencies, set output power, and transmit using the microphone.
Describes VFO, Memory, and Call modes for transceiver operation.
Explains how to operate on the main and sub bands and change between them.
Covers calling, programming, clearing, and transferring memory channels for versatile operation.
Explains how to monitor signal levels around frequencies using VFO or memory channel scope.
Details band, programmed, and memory scanning types, including setting scan resume conditions.
Describes how to monitor a specific priority channel while scanning other frequencies.
Covers setting transmit/receive frequency shifts, splits, and reversing frequencies.
Explains how to adjust tuning steps and activate the key lock function for operational control.
Details procedures for cloning transceiver data and resetting the CPU to factory defaults.
Explains how to set tone frequencies for quiet standby and selective reception.
Covers code squelch, group pager, and private pager modes for selective communication.
Details programming and transmitting DTMF codes automatically using memory.
Lists and explains commands for controlling transceiver functions using the DTMF microphone.
Provides a comprehensive explanation of each remote control command code and its function.
Guides on connecting equipment and operating the transceiver for 1200 bps packet communication.
Guides on connecting equipment and operating the transceiver for 9600 bps packet communication.
Provides solutions for common problems like no display, no sound, or unresponsive controls.
To Next Page
