Alinco DR-510T - User Manual

ALINCa
i i ii i i iiii ii i iiiii
VHF/UHF DUAL BAND FM TRANSCEIVER
INSTRUCTION MANUAL
DR-510E
ALINCO ELECTROMICS INC.

Summary

Specifications Overview

General Specifications

Covers frequency coverage, antenna impedance, power supply, and current drain.

Transmitter Details

Details output power, emission mode, modulation, deviation, spurious emission, microphone, and operating mode.

Operation Controls

Front Panel Controls

Identifies and describes the main dial, display panel, volume, squelch, H/L switch, and power switch.

Function Keys

Key Function Descriptions

Details the MHz, VFO/M, REV, SHIFT, TONE, PRI, SCAN, and CALL keys.

Function Operations

Advanced Tone and Repeater Features

Tone Squelch (CTCSS)

Repeater Offset Operation

Covers setting up repeater offsets and directions.

Transmission Modes

Simplex Transmission

Details the procedure for simplex transmissions.

Dual (Full Duplex) Transmission

Explains how to perform full duplex cross-band operation.

Installation Guide

Mobile Installation

Provides guidance on mounting the transceiver in a vehicle and power.

Base Station Setup

Details requirements for fixed base operation, including power supply.

Alinco DR-510T Specifications

General

Mode	FM
Channel Capacity	200
Voltage	13.8 VDC
Current drain RX	0.5A
Memory channels	200
Type	Mobile
Frequency Range	144-148 MHz (VHF), 430-450 MHz (UHF)
Output Power	50W (VHF), 35W (UHF)
RF Power output	50W (VHF), 35W (UHF)