Need help?Do you have a question about the Alinco DR-510E and is the answer not in the manual?
General| Brand | Alinco |
|---|---|
| Model | DR-510E |
| Category | Transceiver |
| Language | English |
Details on frequency coverage, power supply, current drain, dimensions, and weight.
Technical details for the transmitter including output power, emission mode, and deviation.
Technical details for the receiver including system, acceptance, IF, sensitivity, and selectivity.
Information regarding the built-in DTMF encoder functionality.
Identification and function of front panel controls like Main Dial, Display, Volume, and Squelch.
How to use the Power switch and the F (Function) key for secondary operations.
Detailed explanation of individual function keys (MHz, VFO/M, REV, SHIFT, TONE, PRI, SCAN, CALL).
Explanation of various indicators shown on the transceiver's display panel.
Details on connecting an antenna using a PL259 plug.
Information on connecting the DC power cable and an external speaker.
How to select bands (VHF/UHF) and frequency steps.
How to enable/disable key lock and beep sounds.
How to skip unwanted memory channels during scanning.
Procedure for entering and using the CALL channel (DR-510T only).
Steps to reset the transceiver's microprocessor to factory settings.
Details on memory channels, their contents, and entry procedures.
How to perform a scan based on frequencies stored in memory channels A and B.
How to scan through programmed memory channels.
How to scan the entire tuning range of VHF or UHF bands.
How the transceiver scans a priority memory channel periodically.
How the transceiver scans a VFO frequency while monitoring a priority memory.
How the transceiver scans the CALL channel periodically.
How to select CTCSS tone frequencies for communication.
How to enable/disable CTCSS squelch for clear reception.
How to configure frequency offsets for repeater communication.
How to reverse the transmit and receive frequencies for repeater pairs.
Steps for simplex (1/2 Duplex) transmission.
Steps for full duplex cross-band transmission.
Guidelines for installing the transceiver in a vehicle.
Details on power connections for mobile and base station use.
Guidelines for installing the transceiver for fixed base operation.
To Next Page
