Alinco DR-510E - Transmission Procedures; Simplex Operation; Dual Operation (Full Duplex)

TRANSMISSION
Caution
1. Ensure that an antenna with a low
Standing wave ratio (SWR) is
attached to the antenna connector
before attempting to transmit. Fail-
ure to provide proper terminatlon
may result in damage to the final
ampiifier section.
2. Always check to ensure the fre-
quency is clear before transmitting.
A. Simplex Operation
1/2 Dupiex (Repeater)
Operation
1. Select the desired band (VHF,
UHF).
2. Select the desired operating fre-
quency using any of the methods
described above.
3. Press the microphone PTT switch.
The ON AIR indicator will light.
4. Speak into the microphone. The
recommended distance to the mi
crophone is 2 inches (5 cm). Talking
too far away may result in reports of
weak audio.
5. Release the microphone PTT switch
to return to the receive mode. The
ON AIR indicator should go out.
B. Duai Operation
(Fuii Dupiex)
1. Select the desired transmit fre-
quency.
2. Press the F key and select the
Memory "d".
3. Press the F key and the MW key to
Store the transmit frequency into the
Memory "d".
4. Press the F key and the BAND key
to change to other band.
5. Select the receive freqency by the
usual means.
6. Press the SHIFT key to select the
DUAL on the display.
7. Key the PTT switch and you will
transmit on one band while simul-
taneously receive the other band—
Füll Dupiex Cross Band.
-14-