Need help?Do you have a question about the Alinco DR-590T and is the answer not in the manual?
General| Output Power (VHF) | 50W |
|---|---|
| Modulation | FM |
| Voltage | 13.8 VDC |
| Antenna Connector | SO-239 |
| Frequency Range | 144-148 MHz (VHF), 440-450 MHz (UHF) |
| Receiver System | Double conversion superheterodyne |
Details output power, emission mode, modulation, deviation, spurious emission, microphone, operating mode, duplex, and DTMF encoder.
Outlines receiving system, modulation acceptance, intermediate frequency, sensitivity, selectivity, audio power, and speaker impedance.
Details the primary controls on the front panel of the transceiver.
Covers initial settings, frequency selection, and step selection for receiving.
Covers transmission cautions, tone selection, and transceiver modes.
Explains different scan types like band, programmable, and memory scan.
Details VFO, Memory, and CALL priority scanning modes.
How to set repeater offsets and directions.
To Next Page
